THUMBS UP Tyre repair kit

The set includes:
Screw for cleaning the hole - 1 pc.
Screwdriver for inserting the pin into the tyre- 1 pc.
CO2 tank - 16 g - 2 pcs.
Hose - 1 pc.
Pins for filling holes in the tyre- 5 pcs.

Remember to reduce your driving speed after the repair and try to avoid potholes or bumps on the road.
One tank is enough to inflate a 180/55-R17 tyre to 2.2 bar (32 psi).

Repair manual with repair kit:
1. Mark the tyre damage area with chalk, then remove the nail or other foreign object stuck in the tyre.
2. Using the auger, clean the hole, remember to clean the angle of the hole.
3. Wrap the pin around the middle of the needle. Then push the pin firmly into the puncture hole so that the pin goes through all the layers of the tyre. Remember that the pin should protrude about 1 cm above the tread (if necessary, cut off the excess with a knife).
4. Pull the spike out of the tyre sharply, avoiding twisting the spike as this may break it.
5. Use a knife to cut the excess wire as close to the tread as possible.
6. The wheel is ready for use, you just need to inflate it.
7. Please note that the tool must be inserted at the same angle as the damaged tyre.