THUMBS UP inner tube / tyre repair kit

The set includes: 
8ml glue
Patches 3 x 25 mm (no glue required)
Patches 2 x 30 mm (no glue required)
Patches 1 x 35 mm (no glue required)
CO2 reservoir
Spigot + AV/DV reducer
Tyre removal tools - 2 pcs.
Valve wrench
Tray

Repair manual with repair kit:
1. Mark the area of tyre damage with chalk, then remove the nail or other foreign object stuck in the tyre.
2. Using a screw, clean the hole, remembering to clean the puncture angle.
3. Wrap the pin around the centre of the hole. Then push the yawl firmly into the puncture hole so that the pin passes through all layers of the tyre. Remember that the pin must protrude about 1 cm above the tread (cut off the excess with a knife if necessary).
4. Pull the pin out of the tyre sharply, avoiding twisting the pin as this may cause breakage.
5. Use a knife to cut the excess wire as close to the tread as possible.
6. The wheel is ready for use, just inflate it.
7. Note that the tool must be inserted at the same angle as the damaged tyre.